Two Products in One. Pro-Grade Protection with a Glossy Wet Look.

The Techniseal JSW Sealer & Joint Stabilizer – Wet Look is a professional-grade, water-based paver protector that seals your hardscape and stabilizes the joints at the same time. Made with advanced hybrid resins, JSW locks sand and aggregate joints in place, enhances the natural color of your pavers, and finishes the surface with a rich, permanent wet-look gloss.

Whether you're refreshing a patio, pool deck, or walkway, JSW delivers the polished finish homeowners love with the durability contractors trust — in a single application.

Key Features & Benefits

• Permanent wet-look gloss finish — enhances and deepens paver color for a vibrant, "just-rained-on" look
• Stabilizes paver joints — stops the movement of polymeric sand, regular joint sand, and permeable aggregate joints
• Blocks stains and contaminants — transparent film prevents oil, dirt, and grime from penetrating the surface
• Resists de-icing salts, acids, and alkalis — protects against chemical deterioration year-round
• Water-based formula — low odor, no harsh fumes, and environmentally friendly
• Easier maintenance — sealed surface is quicker to clean and stays looking new longer
• Professional-grade — trusted by hardscape contractors across North America

Ideal For

Concrete pavers and interlocking pavers on patios, walkways, pool decks, driveways, garden paths, and other hardscape installations.

Note: Do not apply to natural stone, wet-cast pavers, stamped or poured concrete, or polished surfaces. For those surfaces, see Techniseal's JSS Wet Look Sealer.

Coverage

One gallon covers approximately 150 sq. ft. Actual coverage may vary depending on joint width and paver porosity. Always refer to the product's technical data sheet for full application details.

Application Conditions

• Surface must be clean, dry, and warm to the touch
• Air and surface temperature must be between 50°F and 80°F (10°C–26°C)
• No rain forecasted for 24 hours after application
• Turn off sprinkler systems before and during drying
• Always test on a small hidden area (~4 sq. ft.) before full application
• Keep from freezing during storage

Quick Install Overview

Clean and dry the paver surface → perform absorption test → apply Techniseal JSW with a sprayer or roller in a consistent, even pass → allow to dry fully before foot traffic. Reapply every 2–3 years (or once the protector shows visible wear) to maintain color enhancement and joint stability.

Protect your investment and bring your pavers to life. Order your gallon of Techniseal JSW Sealer & Joint Stabilizer – Wet Look today.